Appliance EnergyCost Calculator

Why refrigerator electricity use changes through the day

A refrigerator does not draw a steady amount of power. Its compressor runs, rests and runs again as the inside warms up, and how often it runs depends on the room, the door and what you put inside. That is why one wattage reading cannot tell you what it uses in a day.

Published

How a fridge keeps cold

A refrigerator does not make cold; it moves heat. A fluid called the refrigerant picks up heat from the inside of the cabinet and carries it to coils on the outside, where it is released into the room. The compressor is the pump that keeps this going.

In a fridge with a fixed-speed compressor, a thermostat or temperature sensor controls the cycle. Heat leaks in through the walls and the door, the inside slowly warms, and once it passes the set point the compressor starts. When the inside is cold enough, it stops. On a plug-in monitor this shows as a pattern of low readings and higher readings that repeats through the day.

Some fridges have a variable-speed compressor instead. It runs faster when more cooling is needed and slower when less is, so the readings change more gradually, but they still change.

Other parts that use electricity

Depending on the model, fans move air across the cooling coil or the condenser, a light comes on when the door opens, and an ice maker or water dispenser has its own valves and motors. The Department of Energy suggests considering models without an ice maker or water dispenser, which use less energy. Frost-free (automatic defrost) models also clear frost from the cooling coil from time to time, which can appear on a monitor as a short period of different power; how and when this happens varies between models, and the manual describes it.

What makes a fridge work harder

Anything that adds heat, or makes it harder to get rid of, makes the compressor run for longer. Official guidance from ENERGY STAR and the U.S. Department of Energy points to the same things:

  • A warm room or a warm spot. Keep the fridge away from an oven, a dishwasher and direct sunlight. On a hot day, or in a warm kitchen, it will run for longer.
  • Room to breathe. The fridge releases heat from its coils, so leave a few inches between it and the wall, and keep the condenser coils clean on older models.
  • The door. Each time it opens, cold air spills out and warmer air comes in. ENERGY STAR advises keeping the time the door is open short.
  • Door seals. Seals should be airtight. The Energy Saver Guide's test: close the door on a sheet of paper so it is half in and half out; if it pulls out easily, the seal may need attention.
  • Uncovered food and drink. The Department of Energy notes that uncovered foods release moisture and make the compressor work harder.
  • The temperature setting. Both ENERGY STAR and the Department of Energy recommend 35 to 38°F (about 1.7 to 3.3°C) for the fridge, and the Department of Energy suggests 0°F (about −18°C) for a stand-alone freezer. Colder than needed means more running.
  • Food you have just put in. Warm food and drink bring heat with them, which the fridge has to remove, so the compressor runs longer for a while afterwards. Follow food-safety advice on cooling cooked food; do not leave it out to save electricity.
  • Size. ENERGY STAR notes that, generally, the larger the refrigerator, the more energy it uses.

None of these has a fixed effect. How much each one matters depends on the fridge and the room, which is why measuring your own fridge is more informative than any rule of thumb.

Why one wattage reading is misleading

Watts measure power at one moment; kilowatt-hours measure energy over time. A monitor that shows a high reading while the compressor runs is telling you the truth about that moment, not about the day.

As an illustration, imagine a fridge that draws 120 W while cooling for a total of 8 hours a day and 5 W for the other 16 hours. The day's energy is 120 × 8 ÷ 1,000 = 0.96 kWh plus 5 × 16 ÷ 1,000 = 0.08 kWh, so 1.04 kWh. Taking the 120 W reading and multiplying it by 24 hours would give 120 × 24 ÷ 1,000 = 2.88 kWh, nearly three times as much. These are made-up numbers for the arithmetic, and a real fridge has more than two states, but the point holds: the daily total depends on how long each state lasts.

How long to measure

Use a plug-in electricity monitor that adds up kWh, and check that it is rated for the fridge's plug and current. Reset it, let the fridge run as normal and read the kWh after at least 24 hours, so that the measurement includes a full day of cycling, door openings and any defrost. A week is better, because one day can be unusually hot or busy. Divide the total by the number of days for a daily average, or multiply it up to a year.

Smart-meter data shows the whole home, so it is harder to separate the fridge from everything else. See how to measure real appliance electricity use for both approaches.

What the energy label tells you

Fridge labels give a yearly figure from a standard test. The U.S. EnergyGuide label shows the estimated yearly electricity use in kWh, and the EU label shows the annual energy consumption in kWh. These are good for comparing models and for a first estimate. Your fridge can use more or less at home, depending on the room, the setting and how often the door opens. The guide to energy labels shows where the figure appears.

From a yearly figure to a daily cost

Take an illustrative label figure of 360 kWh a year and an illustrative price of $0.20 per kWh. Neither is a typical value: use your own label and your own price.

An illustrative 360 kWh a year at $0.20 per kWh
PeriodEnergyCost
Day0.99 kWh$0.20
Week6.9 kWh$1.38
Average month30 kWh$6.00
Year360 kWh$72.00
  • Day: 360 ÷ 365 = 0.9863 kWh; 0.9863 × 0.20 = $0.1973, about $0.20.
  • Week: 360 ÷ 365 × 7 = 6.9041 kWh; × 0.20 = $1.3808, about $1.38.
  • Average month: 360 ÷ 12 = 30 kWh; × 0.20 = $6.00.
  • Year: 360 × 0.20 = $72.00.

The refrigerator electricity cost calculator does this from the yearly kWh on the label. If you have measured your fridge, enter the measured yearly kWh instead (daily average × 365); it already includes the cycling, so there is no need to estimate how long the compressor runs.

Related guides

Sources

These sources support specific statements on this page. They do not review or endorse this calculator or its results. Last reviewed .

How this guide was written

The first draft was written with the help of an AI writing assistant. It was then edited, every calculation was worked through again, and each factual statement was checked against the sources listed above; statements that could not be checked were removed. Example figures are illustrations chosen to show the arithmetic, not measurements or typical values. See the methodology for how the calculators work.